Look at the bunk with the camper set up
Raise and support the camper as its manual directs. From inside the bunk, close the screen and open the solid window flap. Look toward daylight. Is the gap in the middle of the net, along the stitching, or between the bunk fabric and the bed? Only the first of those gaps is a good bet for a stick-on mesh patch.
Try the zipper and check the edge under the mattress before you buy. If the net is whole and a loose bunk skirt leaves a gap, refit its original fasteners. A patch in the window would leave the real entrance open.
Match the purchase to the part that failed
- One snag in the open mesh: buy a mesh patch.
- Best when the rest of the window bends without splitting and the patch can lie flat. It costs little and leaves most of the view clear. You will still see a ring on the window.
- A torn edge, broken zipper or long split: ask for a window repair.
- A canvas shop can tell you whether to restitch an edge, replace the zipper, or sew fresh netting into the existing wall. You keep the rest of a good bunk end, but you may need to remove it and ship it.
- Several weak layers: price a fitted bunk end.
- If the net tears in several folds and the fabric holding it is also failing, a new screen leaves you with the same weak border. Ask for a single bed wing before paying for both ends or the whole tent.
A pop-up has more than one kind of window. If a rubber cord holds the screen in a rigid frame, follow the screen spline sizing guide. A roller and spline do nothing for mesh sewn into a soft bunk wall.
Will a 3-inch round cover the tear?
Cut a 3-inch circle from scrap paper and lay it over the hole before you order. The circle shows the outside edge of the patch. The hole must sit inside the mesh center so the entire sticky rim lands on sound material. Keep the paper off the zipper teeth, piping and raised seams.
A 3-inch split uses up the width of a 3-inch patch. There is no spare room at the tips. By contrast, a small snag in the middle of a wide window can leave room all around. The size of the bed and the floor area of the camper do not tell you which repair fits.
The GEAR AID listing above is the two-pack offer: two retail packs, two rounds per pack. For one hole, a single retail pack may be enough. If you use a patch on each side, four rounds cover two such repairs, with no spares left. Several holes along the same fold are a reason to inspect the whole window before stocking up.
Apply the patch without sealing the window shut
Open the solid flap and move it clear of the net. Follow the patch directions to clean and dry the repair area. Support it from behind on a flat surface. With the torn edges resting in place, peel the backing, center the patch and press from the middle out. Check the rim for a lifted edge. GEAR AID says to wait at least 24 hours before washing.
Close the flap and work the zipper gently. The patch should move with the net without catching the other layer. Inspect it again when you next unfold the camper. If a fold pulls up the rim or new holes appear beside it, ask about a sewn screen. Adding another row of patches will not fix weak mesh.
Use this on insect mesh only. It lets air through and will not seal a rain leak in clear vinyl or canvas. Keep vents, labels, latches and emergency exits clear. A repaired screen is still not a guard against falling out of a bunk.
What to send a canvas shop
Take three photos: the whole bunk from outside, the full window from inside, and the tear beside a ruler. Include the window width and height, which edge has the zipper, and whether the clear or solid flap still closes. Ask for a screen-only repair and a single-bunk quote so you can compare the same work.
For a new bunk end, write down the year, make, exact model, and whether the damage is at the front or rear. A mattress width alone cannot identify the roof track, wall shape or fasteners. Bear Creek Canvas asks for camper details and may need the old tenting as a pattern. Keep the original until the supplier tells you what to send or you have checked the new fit.
Budget for one finished window
About $10–$25: a planning allowance for small mesh patches in the US. A pack makes sense if the window passes the paper-circle check. It is money wasted if the hole reaches the zipper.
For a sewn window: get a written quote. Ask about removing the tenting, sewing the mesh, replacing a zipper if needed, shipping both ways and fitting it back on. Comparing just the price of a roll of mesh with a shop bill leaves out most of the work.
Roughly $400–$2,500: a broad planning range for larger canvas or bunk-end jobs, based on one US repair shop’s published range. The low end is not a promise for a custom bunk. Check whether the quote covers one end or the whole camper. Ask when it will be ready before taking apart a camper you need for a trip.
If the mesh is sound, check the opening
Look along the entry door and the join between the tenting and trailer body. Repairing a loose closure can cost nothing. For those gaps, use the RV mosquito-control guide. For a hole in a separate camping tent, see the tent mesh repair guide.
A repaired bunk protects the sleeping space only while the openings are closed. If you need protection while sitting outside, the Sawyer skin repellent page explains a separate option. Use the product finder if the bites happen away from the camper.
Compare options before you order
Choose these rounds only if the whole adhesive ring fits on sound mesh. For a torn edge, put that money toward a sewn repair.
Paid links: As an Amazon Associate, we earn from qualifying purchases. Check Amazon for current price, stock and the selected model.
Patch a small hole in sound mesh
GEAR AID Tenacious Tape mesh patches, 3-inch rounds, 2 packs (4 patches)
Four peel-and-stick mesh rounds let you mend a small tear and keep spares for the next trip.
Before you buy: The adhesive ring needs intact mesh on every side. Skip these for split seams, failing zippers or brittle netting.
Check price ↗
Questions about camper screens
Do I need new tenting for one torn window?
Usually not. Check the mesh, its stitched border and the surrounding wall. One hole in strong mesh may need only a patch. An intact wall can often take a new sewn screen.
Will a 3-inch patch fix a 3-inch hole?
No. The adhesive ring needs sound mesh beyond the damage. A hole as wide as the patch leaves nothing for the ring to grip at its widest points.
Does the Amazon two-pack contain two or four patches?
This selection contains four 3-inch rounds: two retail packs with two patches in each. The single-pack option contains two rounds.
Can I put a patch on both sides?
GEAR AID suggests a second patch on the reverse for added strength. Check that both rims sit flat and clear the zipper and flap. A second patch cannot make brittle netting sound.
What if the mesh is pulling away from the zipper?
Ask a canvas shop to inspect the seam and zipper tape. A round patch needs a flat border and should not bridge moving zipper teeth.
Can I use screen spline on the bunk window?
Only if the mesh actually sits in a frame groove with a removable cord. A sewn-in bunk window needs a patch or sewing. Match the repair to the edge you see.
Does screen mesh stop rain?
No. It lets air and water through. If rain enters with the solid flap shut, inspect that flap, its seams and the surrounding tenting separately.
Will a patch stop a pet pushing through?
Do not rely on it for that job. It closes a small insect opening; it does not reinforce a bunk wall or restrain a pet.
Can I replace just the front bunk end?
Some suppliers offer a single bed wing. Send the camper year, make, model and photos, and identify the front or rear bunk. Ask the supplier to confirm fit before ordering.
Should I throw away the old canvas after measuring?
Keep it. The maker may need it as a pattern, and it helps you check the attachments and fit of the new section.
What if the trip is next week?
A small patch can be practical if the damage fits and the surrounding mesh is sound. For a torn seam or failed zipper, ask about shop lead time before removing the bunk end. Arrange another sleeping space if the opening cannot close.